How To Teach A Kid To Increase Baseball Or Softball Hitting Power & Bat Speed With LESS Hip Rotation Batting Drills

Discover how to teach a kid to increase baseball or softball (fast-pitch and slow-pitch) hitting power and bat speed with LESS hip rotation batting drills.  PLEASE NOTE: power isn’t ALL in the hips as some may say.  After exploring this post, you’ll see why we feel ‘load and explode the hips’ or ‘fire the hips’ cues are overplayed, doing more harm than good.

“What Baseball Batting Drills Work To Stop Dipping Back Shoulder?”

PLEASE NOTE: this baseball batting drills post presupposes the hitter is getting an extreme barrel vertical angle at impact.  In other words, they’re intersecting the pitch plane from down to up.  Dipping the back shoulder is inevitable…this blog post goes into fixing extreme uppercut cases.

In this baseball batting drills video, we answer the reader question above.  We go over:

• Springy fascia & tracking the front shoulder,
• Mechanical dominoes that cause upper cutting, and
• A couple fixes…

Springy Fascia & Tracking the Front Shoulder

Here are other Hitting Performance Lab baseball batting drills posts on springy fascia and the spinal engine – and tracking of the front shoulder:

• How to Turn a Beach Towel into a Hitting Demonstration
• Is Rotating the Back Hip Through the Zone Necessary for Power?
• 4 Tips on How to Train Springy Fascia
• Jose Abreu Power Secret Found in an Unlikely Place
• Matt Kemp Video: Unique Ted Williams Power Secret

Mechanical Dominoes that Cause Upper Cutting

Here is a baseball batting drills list of faults I find that CAN contribute to upper cutting:

1. Poor barrel launch angle,
2. Hands drop,
3. Upward shoulder angle at landing,
4. Racing back elbow,
5. Steep front upper arm at landing, and
6. Too much downhill shoulder angle…

#1 would be a hitter having a flat bat, or close to flat, at stride landing. This shifts the bat’s center of mass behind the hitter (instead of above).

#2 can exist on any pitch height or just pitches down in the zone.  The hands don’t travel down, then forward.  They travel down AND forward.  Think of hand path like a right triangle – we want hypotenuse.  The higher the pitch, the flatter the hypotenuse.  The lower the pitch, the steeper the hypotenuse.

An upward shoulder angle at landing, #3, will most likely result in uppercutting and/or a collapsing of the backside.

#4, racing back elbow causes the barrel to get really steep early in the hitting zone, which leads to a lot of weak fly balls to the opposite field.  AND, because of the steep vertical angle of the barrel, a significant roll over correction will happen later in the barrel’s path, resulting in grounders to the hitter’s pull side.

About #5, if the front elbow gets caught ‘tucked in’ at landing (elbow pointing down at the ground), then an uppercut will most likely happen.  And this ‘tucking’ will happen most likely because of #6, too steep of a shoulder angle.

Baseball Batting Drills Fix…

1. High tee inside setup using end loaded overload bat,
2. Flashlight barrel angle drill,
3. Hands Drop Drill,
4. Finger pressure (bottom three fingers of the top hand only), and
5. Swinging down in the ‘launch angle’ era.